Beverage-Air 712-047D-12 Drawer Gasket – WTXCS48 Medium

Beverage-Air 712-047D-12 Drawer Gasket

Beverage-Air OEM part number 712-047D-12 identifies a replacement drawer gasket for commercial refrigeration equipment. Beverage-Air's parts catalog describes this component as the WTXCS48 medium drawer gasket. Match the complete equipment model, serial number, and original gasket before ordering.

The gasket seals the perimeter of the closed drawer. Replacing a torn or permanently deformed seal can help restore consistent contact between the drawer and cabinet. This part is intended for commercial refrigeration service in restaurants, foodservice kitchens, and other facilities using the applicable Beverage-Air equipment.

Part Identification and Specifications

When to Inspect or Replace the Drawer Seal

• Splits, torn corners, or missing sections in the sealing surface.
• A gasket that remains flattened, distorted, or separated from its mounting channel.
• Visible gaps between the gasket and cabinet when the drawer is fully closed.
• Moisture or frost concentrated around a gap in the drawer seal.

A warm cabinet or extended compressor operation does not prove the gasket is the only fault. Check drawer alignment, slide movement, product obstruction, and the cabinet contact surface as part of the diagnosis. A new seal cannot correct a bent drawer or worn slide assembly.

Before You Order

1. Match OEM number 712-047D-12 with the equipment's parts documentation or confirmed replacement reference.
2. Record the complete model and serial number. The WTXCS48 catalog reference does not establish fit for every drawer arrangement or equipment revision.
3. Compare the original gasket's cross-section, mounting profile, corner shape, and installed dimensions.
4. Use the same measurement method for both gaskets. Outside-edge dimensions and mounting-center dimensions are not interchangeable.

Size clarification: Published descriptions for this part vary. Confirm the measurement method and equipment application before selecting it by size alone. Send your model/serial plate, a full gasket photo, a profile photo, and measurements if you need help identifying the correct seal.

Installation and Service Checks

Follow the equipment service instructions and isolate power before service. Inspect and clean the gasket mounting area and cabinet contact surface without damaging them. Fit the replacement evenly without stretching it, then confirm that the corners sit correctly and the drawer closes freely. Inspect contact around the entire perimeter and recheck cabinet temperature after the equipment returns to normal operation.

Frequently Asked Questions

What is Beverage-Air 712-047D-12?

It is the OEM part number for a refrigerated drawer gasket. Beverage-Air's catalog identifies the application as the WTXCS48 medium drawer.

Will this gasket fit every Beverage-Air drawer?

No. Verify the full model and serial number, drawer configuration, and original part reference. Brand name or cabinet width alone is not enough to confirm fit.

Should I order by the listed dimensions alone?

No. Published size descriptions differ for this number. Confirm whether measurements refer to the outside edges or another reference point, and compare the mounting profile before ordering.

What photos help confirm the correct replacement?

Provide the equipment model/serial plate, the complete drawer gasket, a clear cross-section of the mounting profile, and photos showing how the dimensions were measured.

Can this gasket fix a drawer that does not close evenly?

It can address a damaged seal, but it will not repair misaligned slides, a bent drawer, or an obstruction. Correct mechanical closure problems before evaluating the new gasket.

Does this include the drawer or slide hardware?

No. This listing is for one replacement gasket. The drawer assembly, slides, and other hardware are separate components.

What should I check after replacing the gasket?

Check that the gasket is seated evenly, the corners are positioned correctly, and the closed drawer makes continuous seal contact. Monitor operation after the cabinet stabilizes.

Related Parts and Fitment Resources

Browse Beverage-Air replacement parts or visit our Beverage-Air parts and fitment guide for help matching commercial refrigeration components.