Beverage-Air 32C01-003A Replacement SM58 Gasket Set

Beverage-Air 32C01-003A SM58 Gasket Set

Commercial replacement part. Beverage-Air 32C01-003A seals the opening on the specified refrigeration application, helping limit warm-air entry when the door, drawer or lid is closed. Matching the profile and mounting arrangement is as important as matching the part number.

When to inspect or replace this part

Inspect the seal for split corners, hardened material, flattened sections or gaps against the cabinet. Condensation, frost near the opening and frequent compressor operation can accompany a poor seal, although door alignment and other equipment faults should also be checked.

Specifications

Compatibility and ordering checks

Catalog application references: SM58. Verify the serial-specific parts list before ordering.

Match the original part number and the equipment model and serial number. Compare the seal profile, attachment style and all four sides with the original. Gasket measurements may be reported at the outside edge, dart centerline or another reference point; use the same measuring convention.

Installation and service

Clean the mounting surface and inspect the hinges, drawer slides or lid alignment before fitting the replacement. Seat the gasket evenly without stretching the corners. Close the opening and check for uniform contact around its perimeter.

Frequently asked questions

What is the 32C01-003A used for?

Beverage-Air 32C01-003A seals the opening on the specified refrigeration application, helping limit warm-air entry when the door, drawer or lid is closed. Matching the profile and mounting arrangement is as important as matching the part number.

Which models use 32C01-003A?

Catalog application references: SM58. Verify the serial-specific parts list before ordering.

Will a gasket with similar dimensions fit?

Dimensions alone are insufficient. The mounting profile, corner construction and application must agree with the original seal.

Can a new gasket correct a misaligned door or drawer?

A new seal cannot correct worn hinges, damaged slides or a distorted frame. Resolve alignment problems so the gasket can make even contact.

Should the gasket be stretched during installation?

Fit it evenly using the equipment manufacturer's instructions. Stretching can pull corners out of position and create new air gaps.

How do I check the seal after installation?

Inspect the full perimeter for consistent contact, confirm normal closure and monitor the equipment for persistent condensation or temperature problems.

Need help confirming the replacement? Have the model, serial number and original part number ready and call 631-873-0509.

Browse Beverage-Air replacement parts and commercial refrigeration parts or refrigeration gaskets.